Quantum Instruments Camera Flash QFT5d-R User Manual

0

Out of 0 Ratings

Owner's of the Quantum Instruments Camera Flash QFT5d-R gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 40
 
32
16.2 Wireless lighting ratios made easy
When using multiple lights to light a subject it’s very easy to set up a light-
ing ratio between the Main and Fill lights. The ratio can be set from –3
stops to +3 stops.
Equipment needed:
• One Qflash 5d-R
• One Qflash
(any version)
located to the right
of the subject
•Two FreeXWires
•Two QF30 cables
•Two Quantum
Turbo batteries
Set up:
• Connect the equipment as shown.
• Set the Main flash to TTL mode.
• Set the Fill flash, located at the camera
position to Auto mode. Select an F number that is less
than the
F number set on the camera. Typically it is set to one stop under the
camera’s aperture, but can be as low as 2-1/2 stops under.
• Next Adjust the Linked ratio for the difference between Fill flash and the
camera’s aperture.
Example. If the camera is set for F8.0, and the Fill is set for F5.6, the Linked
ratio needs to be set to +1 ( the camera is one stop higher than the Fill)
16.3 Lighting ratios using a control cable
This set up is similar to the wire-
less one above, only Qflashes
are connected with QF50
cables instead of FreeXWires.
Equipment needed:
• One Qflash 5d-R located
at camera position
• One Qflash / 2/ 2d/4d/5d
located to the right of the
subject
• One QF50 control cable
•Two Quantum Turbo batteries
Set up: Same set up as above.
QFT5D INSTRUCTIONS 10/5/06 10:27 AM Page 36

   Find Your Products By Category