5.0
Owner's of the Quantum Instruments Camera Flash QFX5d-R gave it a score of 5.0 out of 5. Here's how the scores stacked up:
11
5. Fire Qflash. Push the the Option ■ button, until the compensation dis
play appears.
6. Use the Set G and Up J button to increase light output (if flash meter
reads less than F 8.0), or the Down L button to decrease light output
(if flash meter reads more than F 8.0). The light output can be increased
or decreased by as much as 2 stops in 1/3 steps.
8.3 Option Menu 3
FW7Q Zone Control
This option menu is only available when a FW7Q is attached to the Qflash.
With this option menu you can access the zone and the range settings of
the FW7Q.
You can enter this menu by pushing the Option ■ button until it shows up
on the Qflash’s display. The Set G button will cycle through the available
settings. Use the Up J/Down L buttons to make a change.
8.4 Restoring Factory settings
Qflash options and settings are preset at the factory. You can restore the
factory settings by the following method:
1. Turn Turbo or Qpaq OFF. Connect Qflash to Turbo or Qpaq.
2. Press and hold any button (except Test M).
3. Turn Turbo or Qpaq ON.
4. The Qflash will display a reset message.
5. Press Mode I to reset the Qflash and restore the factory settings.
If you push any other button or fail to push the Mode I button within 4 sec-
onds, the Factory settings will not be restored.
QFT5D INSTRUCTIONS 10/5/06 10:27 AM Page 15
Find Your Products By Category
Please Login
